Re: {Chrysler 300} 61 torqueflight torque converter question

[Bob Merritt <bob@xxxxxxxxxxxxx>]

3/8 x 27 and .375" long.

The one I pulled is brass.

3/8 x 27???? Yes, I double checked.

I had not heard of 27" thread before but

I see you can get taps and dies that size

so it does exist........

Bob

On 10/31/2024 9:50 PM, 'Marilyn James' via Chrysler 300 Club International wrote:

Can anyone tell me thread size and bolt size for the drain plug on my 61G.  Any help would be greatly appreciated.

Sent from Yahoo Mail for iPad

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/649879195.4827949.1730425834220%40mail.yahoo.com.

-- 
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
--- 
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/f1ab1b94-fac2-4e2d-b6df-560b6259fb81%40simplexco.com.