First of all thank you to everyone who has responded to my
messages about the 62 Sport, and this 66 300 TNT that I have been
working on. This club and the support it offers is an incredible
resource. Every time I send a message I get a lot of incredible
information. Hopefully soon I get this 66 done and I can stop with
all the questions. I had asked earlier about brake pads for it,
and was able to get a hold of a set. Now I am trying to make the
calipers correct which is tricky. I am working on this car for a
friend, it is not mine. The calipers are sticking so they need
rebuilt or replaced but these fixed mount 4 piston calipers just
do not seem to exist anywhere. Cardone lists them as part number
18-4479 and 18-4480 but they are not obtainable. This car is
pretty rough exterior wise but it is low miles, runs well,
completely original, and complete. So we are trying to make it a
good running car, with minimal investment since it will be hard to
justify. I am hoping to find a set of good calipers, or worst case
rebuild parts. Any info would be greatly appreciated. If I can not
come up with anything I guess we will have to look at doing the
swap that Dan Reitz and Caroll Ripley suggested. Its looking like
that is what I will have to do, but that will take more time and
cost than I would like to get into.
I currently need to find a power steering pump for this car also.
Napa shows one but it is not correct. The return line is smaller
and in a different location and the shaft looks to be different. I
would rather not get into rebuilding this one, does any one know
anywhere to get one?
Drew
Carl Phone: 724-288-6636 Email: Drew@xxxxxxxxxxxx Website: www.escoremx.com Address: 523 Westland Rd. Hickory PA 15340 |