I have been thinking about how to place a back up camera on the 300K. Mounted at or near the license plate it is too low. Mounted inside the rear window is too high.
I am wondering if I can machine a block that is threaded and will stick through the stock hole in the trunk for the lockset. Make a longer flat bar that goes from the keyset into the actual lock…and have enough room to run a camera wire set parallel to it and into the machined block. Inside the block I would also machine a place for the camera to sit.
Then send the block out for chrome and stick it in. The part sticking into the trunk through the stock hole…I would make it threaded to use a large thin nut and not use the dammed clip.
Thoughts? I do not want to drill holes anyplace if I can figure out a way not to.
James
Attachment:
pro-ZwNvq7cd.jpeg
Description: pro-ZwNvq7cd.jpeg