So, I pull the GATES stat that I had purchased to carry in the car and test it. Works, Then I note stamped on the side of it MOTORAD the same crap manufacturer that made the fail open
one that just stuck open. I call around to all the store in the area, everyone either has no name ones or Motorad.
To get Stant or one from one of the HP suppliers and the car will be down for days!
So, I guess I will have to stick the crap Motorad in and cross my fingers… You order Gates and you get some crap in the Gates Box. James From:
'James Douglas' via Chrysler 300 Club International <chrysler-300-club-international@xxxxxxxxxxxxxxxx>
Well, It turns out that it was not the temperature sending unit on my 300K that was causing the gauge to read low. Nor was it the voltage limiter or the gauge. I had some 7 Ohm resisters
around, so I made some up to get to 21 Ohms which is what the water temperature gauge is supposed to be in the middle or 180F position. When I hooked it up the gauge went to about 12 O’clock or the middle of the dial. I figured the sender and the gauge is
good. The 18-month-old thermostat failed. It was one of those units that fails open. That is the only good thing. So, for the second time in 10 days, I had to pull the A/C compress up and out of the way to get to the thermostat housing area. What a PITA Chrysler did in having the thermostat
and the sender buried under the compressor. At lease all the bolts are new and have anti seize on them, so everything comes apart nice. I guess I am going to have to make up a get the compressor off kit with the tolls in a small box with a sender and thermostat to carry in the car in the event one fails again on
the road. Including one of those large bolts to get the pulley and clutch off. I have found it is better to pull the clutch and pulley and take the compressor off the brackets rather than try to pull the compressor with the brackets. I may change the three small bolts that hold the coil to the compressor to hex head so one is less likely to drop them. A hex socket would also go into my little kit for the road. I hate having to redo work due to crap parts. James. --
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang --- You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group. To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx. To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB617124AA103946F59F157D7993762%40CY5PR19MB6171.namprd19.prod.outlook.com. |