{Chrysler 300} Re: Cooling issue or a sensing issue…

We took the 300K to our place 80 miles from San Francisco a couple of days ago. Been hot up here over 100F. Killing us in that I am still working on the A/C.

This morning at 5:30 AM with the ambient temperature at 63F we went rolling down the highway to get breakfast. I noticed that the temperature gauge was staying in the middle of the "cold" arc on the gauge. It is normally about 1/3 on the "running" arc of the temperature gauge.

I pulled of when I could at a gas station and took a look. Nothing seemed amiss. The car did not "small" hot. No hissing. I popped the radiator cap and got very little pressure blowing by so it was not acting like it was boiling over. It was low a bit on water but since I do not have a recovery tank that is normal.

I pilled the temp wire from under the A/C compressor and the gauge dropped to zero. The gas gauge is fine. The LED on the digital voltage limiter was flashing so it is not that.

I have one of those "fancy" fail open thermostat's in the car. I wonder if it failed open, so the car is running cold.

I checked the dip stick and no water showing up on it. I did a heater hose off last week. An air pocket?

Scratching my head. Anyone have any other ideas?

James

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/CY5PR19MB61714E63F5B4251C5F8CE74C93982%40CY5PR19MB6171.namprd19.prod.outlook.com.