Re: {Chrysler 300} Radio antenna for 300F needed...

Hi all, Have 2 photos of my antennas' and parts. I will offer in order of replies. Randle was 1st, but my complete units will not fit fender angle on 60. The base adaptor can be used from a 60 to make work?.

2nd was Dave, 3rd Magnus, 4th Mr. Bob.

I have attached 2 photos that show stock I have:

Top photo is complete nos/nors with used bottom extension tube and bracket that I glass beaded, looks new- $200.

Next are two new mast only- I think these replace 56-61, the most needed part- $125 ea.

Next is a complete unit except cable, I am sure a full radio shop can make this cable-$150.

Very bottom of that photo are some misc. parts including 2 rubber grommets that seals cable where it enters cab- $5 ea.

Last photo shows a cable only that screws onto mast base- $50. This type likely hard to find, The antenna shown is for my car. Chrys. did some cost cutting when they went to crimp on style. FYI, to secure cable on the crimp on style, drill and tap a 8/32 hole where the cable enters mast base. I can do it if you need help to get it done- add $25

S/H will apply. Tell me what you want and I will go in order of your contact.

Take Care and have a Great week-end,

Garythepartsddoc

From: Gary

Sent: Thursday, April 18, 2024 2:06 PM

To: Randal Edison ; Chrysler 300 Club International

Subject: Re: {Chrysler 300} Radio antenna for 300F needed...

I have a couple of NOS manual antennas, I know they fit 57 to 59.

Gary the parts doc

From: 'Randal Edison' via Chrysler 300 Club International

Sent: Tuesday, April 16, 2024 2:05 PM

To: Chrysler 300 Club International