|
Not factory, but had this are problem with my E. Finally put some black household door weather strip on the trunk side of the gasket where isn't very noticeable. Problem solved. Agree with others to use strips if newspaper or similar to find where not sealing. Mine was only at the back window edge of the trunk, so hardly notice the fix. Depends how factory u want Sent from my BlackBerry 10 smartphone on the Rogers network.
Because Chrysler typically had such awful body panel fits, even if you install a new trunk gasket you may still find the trunk lid is not sealed. To make sure of it after your installation, take a tough new dollar bill or a piece of Tyvek house wrap and pull it through between the gasket and the trunk lid all the way around the perimeter. If you find gaps, you will need to find a way to "plump out" the gasket in those areas. You might even have to slip a short piece of bell wire behind the gasket if the gap is large. When you're done, the Tyvek should exhibit friction when pulling it out all the way around the lid. Keith Boonstra - On Tue, Apr 7, 2015 at 8:50 PM, 'Mark Souders' MRS954@xxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:
__._,_.___ Posted by: lindsey@xxxxxxxxxxxxxxx To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or go to https://groups.yahoo.com/neo/groups/all/manage/edit For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang __,_._,___ | ||
Back to the Home of the Forward Look Network
Archive Sitemap