[Chrysler300] 1962 Frame 7 Springs
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Chrysler300] 1962 Frame 7 Springs






Hi Group,
 
Using the 1962 frame chart and calculating the differences between the measurements at points A,D & C and then comparing them with the same data from my H and from my Sport, I find that the rear of both cars are 1&1/4" and 1&1/2'' low.
I am considering having the existing springs re-arched rather than buying new ones thru the club.
By raising the rear with re-arched or new springs, I will in effect will be pivoting the frame about the front wheels which will slightly decrease the 1&1/4" and 1&1/2" measurements.
The one question that I can't find an answer to is what should the measurement form the ground (floor) to the front (point A) of the car be.
I know this will vary with tire size, so what I really need is the correct measurement from the horizontal centerline of the front wheel to point A on the front of the car.
I suspect that the torsion bar adjustments on both cars have been altered.
 
Doug Warrener
 
 


__._,_.___


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to http://autos.groups.yahoo.com/group/Chrysler300/join and select the "Leave Group" button

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang




Visit Your Group
Yahoo! Groups
PrivacyUnsubscribeTerms of Use

__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.