Re: [Chrysler300] C-300 & B wheels

[Anna F Noia <sa-noia@xxxxxxxxxxx>]

The Bolt diameter of 4 1/2 inches is not the only variable on the rims for your use. If all you want is to bolt up to your hubs, then OK. The 300 rim was a sturdier wheel, heavier gauge steel than the standard Saratoga and Windsor. They may also be slightly wider. The New Yorker had the same 5 x 4 1/2 inch

bolt pattern, and may also be of a heavier gauge steel. The early Imperial's had the 5 x 5 1/2 inch bolt pattern. Good luck.

Best Regards,
Stephen A. Noia
1-408-210-4736 cell

From: Charles Schoendorf <cschoend@xxxxxxxxxxxxx>
To: Chrysler300@xxxxxxxxxxxxxxx
Sent: Sunday, January 26, 2014 4:41 PM
Subject: [Chrysler300] C-300 & B wheels

 

I'm looking to purchase up to five steel rims for a C-300 or 300B.  I believe the rims were the same.  Specs are 15" diameter with 4 1/2" bolt pattern diameter.  Prior to '55 I believe that Saratogas and Windsors also had a 4 1/2" bolt pattern, which would work.  NY's and Imp's I believe were 5 1/2" diameter, ruling them out.

 

Many thanks.

 

Chuck, C-300 & a B

__._,_.___

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to http://autos.groups.yahoo.com/group/Chrysler300/join and select the "Leave Group" button

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___