[Chrysler300] Alternator for 1963 Chrysler 300

["Mark Lindahl" <mplindahl@xxxxxxxxxxxxx>]

Hi,

 

I have a dual pully alternator in my ’63 Chrysler 300.  I only need a single pully, but at the time I purchased it (10+ years ago), I think the dual pully was a higher amp unit since the dual pully was intended for AC cars. 

There is a noise coming from the bearing.  I have an extra older single pully alternator and I don’t know it’s working condition. 

Do I need to use a press to remove the defective bearing or is it a simple change to take the old bearing out of the one alternator and put it in the other one?

Is it possible to swap the dual pully for the single pully by taking the two units apart?  Since my convertible does not have AC, the single pully would look correct.

 

According to the service manual, the standard alternator was rated at 34.5 and the upgraded alternator (both single and dual pully) was rated at 39 amps.

 

Thanks,

Mark Lindahl

’63 300 Conv.

__._,_.___

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to http://autos.groups.yahoo.com/group/Chrysler300/join and select the "Leave Group" button

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___