[Chrysler300] Dual-Point Distributor not Distributing!

[John <spiers@xxxxxxxxxxxxxx>]

Hi all,
 
I have a non-ram 300-K coupe with a stock dual-point distributor.  The engine turns over fine with a freshly-charged battery, but I'm getting very little spark, not enough to run.
 
With the cap off, I see a weak spark arcing between one set of points [the set closer to the driver's side of the car], and no spark at all from the other set.
 
I checked both sets of points.  They are nearly new, but I dressed up the faces of the points with a file anyway, and set the gaps.
 
I replaced the coil with one known to work.
 
I replaced the condensor with one known to work.
 
I even ran a wire with spring clamps on each end - one end to the + battery terminal and the other to the + terminal on the coil.
 
I achieved no change at all from any of the above.
 
Can anyone show me where I've gone wrong?
 
Thanks,
 
John Spiers
Lake Worth, Florida


      

[Non-text portions of this message have been removed]


------------------------------------

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/Chrysler300/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:Chrysler300-digest@xxxxxxxxxxxxxxx 
    mailto:Chrysler300-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/