[Chrysler300] 4006452 heads on a 383 engine

[" Mark Lindahl" <mplindahl@xxxxxxxxxxxxx>]

Good Afternoon,

I tried to install some 4006452 heads on my '63 383 engine and I find that the pushrods that I have for the 383 and some for a 413 are too short.  Does anyone know if they make push rods for this combination?

The pedistals for the 452 heads are higher than the original heads 2206324.
Now I don't know the length of the pushrods that are needed.

I may just have the original 383 heads redone, but I was thinking of using the open chamber heads.

Thanks for your help, in advance.  Right now, I'm stumped!

Mark Lindahl

[Non-text portions of this message have been removed]



To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/ 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/Chrysler300/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:Chrysler300-digest@xxxxxxxxxxxxxxx 
    mailto:Chrysler300-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/