[Chrysler300] moulding fasteners

[david dumais <dvd_dumais@xxxxxxxxx>]

On the 300 Sport, the upper rear 1/4 moulding clips have had their mounting holes increased in diameter due to the quarter being pulled during rehab at the body shop.   From what I see,
  the clips hold the aluminum backer in place, and the trim snaps onto same clips.
   
  I can access the clips mounting "stud" from inside the trunk.  Some of the holes are to large for the snug fit needed.    So, I need a method of securing the studs.   
   
  My thought, if I can get all trim assembly to line up, can I use silicon to secure the studs into the metal , or do I need a more aggressive glue, or maybe JB epoxy?
   
  Also, does any one have a clue where to find a 64 4/spd speedo gear for a 3:55/1 ratio?
   
                                           Thanks       300K ly    Dave in Virginia

 __________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 

[Non-text portions of this message have been removed]



To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/ 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/Chrysler300/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:Chrysler300-digest@xxxxxxxxxxxxxxx 
    mailto:Chrysler300-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/