Re: [Chrysler300] 413 pistons .060 over source?

[Ray Jones <hurst300@xxxxxxxxxxx>]

To use 426 pistons, you would have to deal with piston pin location and 
rod length compared to stock 413 pistons/rods.  Likely the same, but ya 
gotta know.
Ray


On Jun 2, 2007, at 8:28 PM, John wrote:

 From Allpar.com:

  "The 413 saw a 4.18 inch hole which directly resulted in an easy leap 
to the NASCAR limit of 426 cubic inches by boring the block to a 4.25 
inch diameter."

  So it would seem that 4.25 - 4.18 = .070" - If a 413 block could be 
bored .070" with no problems, standard 426 pistons may be able to be 
used. I've never done this, so I don't know if it's safe to do so.

  John Spiers
  Lake Worth, FL

[Non-text portions of this message have been removed]



To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/ 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/Chrysler300/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:Chrysler300-digest@xxxxxxxxxxxxxxx 
    mailto:Chrysler300-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/