Howdy, The RB blocks can be primed in that manner. The geared shaft going to the pump must be pulled after the distributor is pulled out. I would put the engine on TDC, align the shaft and the distributor and note the slot alignment in the shaft and the rotor position before starting to facilitate re assembly. Then all it takes is a hex shaft (I put a little shrink wrap on it to protect the bushing). It must turn CCW. I always use a 1/2" drill, since a 3/8" doesn't seem to have the oomph necessary to make oil pressure. Bill Huff At 9/1/04 12:26 PM, Vath, Michael J. wrote: >Happy Wednesday. Mighty quiet out there. Can a 413 or 440 be primed using >the powerdrill rod-down-the-distributor method? > >It works wonders on 392s, but they have that nice slotted gear drive shaft >deal.. If not, where can you find those nifty propane tank-looking >pressurized pre-oilers? > >Many thanks! > > > > >Ps. for sunbelters: >T minus 10 days 'til the Hayes Chrysler Show (and drags) in Commerce, GA >T minus 14 days 'til the Pigeon Forge Fall Rod Run.. > > >To send a message to this group, send an email to: >Chrysler300@xxxxxxxxxxxxxxx > >For list server instructions, go to ><http://www.chrysler300club.com/yahoolist/inst.htm>http://www.chrysler300club.com/yahoolist/inst.htm > > > >Yahoo! Groups Sponsor >ADVERTISEMENT > > >---------- >Yahoo! Groups Links > * To visit your group on the web, go to: > * > <http://groups.yahoo.com/group/Chrysler300/>http://groups.yahoo.com/group/Chrysler300/ > > * > * To unsubscribe from this group, send an email to: > * > <mailto:Chrysler300-unsubscribe@xxxxxxxxxxxxxxx?subject=Unsubscribe>Chrysler300-unsubscribe@xxxxxxxxxxxxxxx > > * > * Your use of Yahoo! Groups is subject to the > <http://docs.yahoo.com/info/terms/>Yahoo! Terms of Service. [Non-text portions of this message have been removed] ------------------------ Yahoo! Groups Sponsor --------------------~--> Yahoo! Autos. Everything you need to know about buying or selling a car. FREE Quotes, 360° Tours, Research, Blue Book, Compare Vehicles, Buy Used http://us.click.yahoo.com/kEZsdA/bwnGAA/YiGOAA/8LmulB/TM --------------------------------------------------------------------~-> To send a message to this group, send an email to: Chrysler300@xxxxxxxxxxxxxxx For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Chrysler300/ <*> To unsubscribe from this group, send an email to: Chrysler300-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/